Epson EH-TW5825 User Manual

Troubleshooting
53
Indicators Status Remedy
(blue)
(orange)
High Temp Error
(Overheating)
The internal temperature is too high.
•
The lamp turns off automatically and projection stops. Wait
for about five minutes. When the fan has stopped, disconnect
the power cord.
•
If the projector is installed next to a wall, make sure there is at
least 20 cm between the wall and the projector's exhaust vent.
•
If the air filter is clogged, clean it. s p.62
•
Make sure that nothing is blocking the area around the inlet
and that the temperature around the inlet is not too high.
s p.73
•
If turning the power back on does not clear the problem, stop
using the projector and remove the power plug from the
electrical outlet. Contact your local dealer or the nearest Ep-
son repair center.
s Epson Projector Contact List
•
When using at an altitude of 1500 m or more, set High Alti‐
tude Mode to On.
s Extended - Operation - High Altitude
Mode p.49
Indicator status during normal operation
: Flashing : Lit : Off
Indicators Status Remedy
(blue)
Standby condition
When you press the standby button on the remote control or
on the control panel, projection starts after a short wait.
(blue)
Warm-up in progress
Warm-up time is about 30 seconds.
The power-off operation is disabled while the projector is
warming-up.
Cool-down in pro-
gress
All operations are disabled while the projector is cooling-
down. The projector enters standby condition when cool-
down is complete. If for any reason the power cord is discon-
nected during cool-down, wait until the lamp has cooled
down sufficiently (about 10 minutes), reconnect the power
cord, and then press the standby button on the remote con-
trol or on the control panel.
(blue)
Projection in pro-
gress
The projector is operating normally.
c
•
When the projector is operating normally, the temperature and lamp indicators are off.
•
When the Illumination function is set to Off, all indicators are off under normal projection conditions.
s Extended - Operation - Illumination p.49

Epson EH-TW5825 Specifications

General

Matrix size	0.61 \
Heat dissipation	1009.8 BTU/h
Number of colors	1.07 billion colors
Native aspect ratio	16:9
Projection distance	2.35 - 3.82 m
Vertical scan range	192 - 240 Hz
Projection technology	3LCD
Contrast ratio (typical)	70000:1
Screen size compatibility	30 - 300 \
Projector native resolution	1080p (1920x1080)
Keystone correction, vertical	-30 - 30 °
Projector brightness (economic mode)	1780 ANSI lumens
3D	No
Full HD	Yes
Video processing	10 bit
Video color modes	Cinema, Dynamic, Natural, Bright cinema
Analog signal format system	Not supported
Lamp type	UHE
Lamp power	200 W
Light source type	Lamp
Service life of light source	4500 h
Service life of light source (economic mode)	7500 h
Throw ratio	1.33 - 2.00:1
Focal length range	18.2 - 29.2 mm
Aperture range (F-F)	1.51 - 1.99
Vertical lens shift range	-60 - 60 %
Noise level	36 dB
Country of origin	Philippines
Operating system installed	Android
Noise level (economic mode)	28 dB
Placement	Ceiling, Desktop
Product color	White
Market positioning	Home cinema
Cable lock slot type	Kensington
RMS rated power	10 W
Power source	AC
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.3 W
Power consumption (typical)	297 W
Power consumption (economy mode)	227 W
Operating temperature (T-T)	5 - 35 °C
Storage relative humidity (H-H)	10 - 90 %
Operating relative humidity (H-H)	20 - 80 %
Pallet weight	0 g
Quantity per pack	1 pc(s)
Quantity per pallet	66 pc(s)
Harmonized System (HS) code	85286200
HDMI version	1.4
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
VGA (D-Sub) ports quantity	0

Weight and Dimensions

Depth	315 mm
Width	309 mm
Height	122 mm
Weight	3800 g
Package depth	410 mm
Package width	380 mm
Package height	180 mm
Package weight	5280 g