Epson EH-TW5825 User Manual

Troubleshooting
58
Projection stops automatically
Check Remedy
Is Sleep Mode enabled?
If the set time is exceeded and no signal is input, the lamp is
automatically turned off and the projector enters standby mode.
Press the standby button on the remote control or on the control
panel to turn on the projector. If you want to disable Sleep
Mode, change the setting to Off.
s Extended - Operation -
Sleep Mode p.49
Noise problems
No audio, or the audio is too low
Check Remedy
Is the audio cable connected correctly? Try disconnecting the cable from the Audio Out port, and then
reconnecting.
Is the volume too low? Adjust the volume so that you can hear the audio.
s p.31
Is it connected with an HDMI cable? If no audio is output when connecting via an HDMI cable, set the
connected equipment to PCM output.
Are the Audio Out Device settings correct? Check that the Audio Out Device settings are correct on the
Configuration menu.
s Settings - HDMI Link - Audio Out De‐
vice p.46
Are the Bluetooth Audio settings correct?
Make the following settings when connecting a Bluetooth audio
device.
•
To output audio from the projector's speaker or an amplifier, set
Bluetooth Audio to Off.
•
To output audio from Bluetooth audio devices, set Bluetooth
Audio to On.
s Settings - Bluetooth - Bluetooth Audio p.46
Problems when projection starts
The projector does not turn on
Check Remedy
Is the power turned on? Press the standby button on the remote control or the control
panel.
Is Child Lock set to On? When Child Lock is set to On from the Configuration menu, hold
down the standby button on the control panel for approximately
three seconds, or perform operations from the remote control.
s Settings - Lock Setting - Child Lock p.46
Do the indicators turn on and off when the
power cord is touched?
Turn off the projector, and then disconnect and reconnect the
projector's power cord. If the problem continues, stop using the
projector, remove the power plug from the electrical outlet, and
contact your local dealer or the nearest projector information
center.
s Epson Projector Contact List

Epson EH-TW5825 Specifications

General

Matrix size	0.61 \
Heat dissipation	1009.8 BTU/h
Number of colors	1.07 billion colors
Native aspect ratio	16:9
Projection distance	2.35 - 3.82 m
Vertical scan range	192 - 240 Hz
Projection technology	3LCD
Contrast ratio (typical)	70000:1
Screen size compatibility	30 - 300 \
Projector native resolution	1080p (1920x1080)
Keystone correction, vertical	-30 - 30 °
Projector brightness (economic mode)	1780 ANSI lumens
3D	No
Full HD	Yes
Video processing	10 bit
Video color modes	Cinema, Dynamic, Natural, Bright cinema
Analog signal format system	Not supported
Lamp type	UHE
Lamp power	200 W
Light source type	Lamp
Service life of light source	4500 h
Service life of light source (economic mode)	7500 h
Throw ratio	1.33 - 2.00:1
Focal length range	18.2 - 29.2 mm
Aperture range (F-F)	1.51 - 1.99
Vertical lens shift range	-60 - 60 %
Noise level	36 dB
Country of origin	Philippines
Operating system installed	Android
Noise level (economic mode)	28 dB
Placement	Ceiling, Desktop
Product color	White
Market positioning	Home cinema
Cable lock slot type	Kensington
RMS rated power	10 W
Power source	AC
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.3 W
Power consumption (typical)	297 W
Power consumption (economy mode)	227 W
Operating temperature (T-T)	5 - 35 °C
Storage relative humidity (H-H)	10 - 90 %
Operating relative humidity (H-H)	20 - 80 %
Pallet weight	0 g
Quantity per pack	1 pc(s)
Quantity per pallet	66 pc(s)
Harmonized System (HS) code	85286200
HDMI version	1.4
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
VGA (D-Sub) ports quantity	0

Weight and Dimensions

Depth	315 mm
Width	309 mm
Height	122 mm
Weight	3800 g
Package depth	410 mm
Package width	380 mm
Package height	180 mm
Package weight	5280 g