Epson EPL-7500 - Removing the Face-Up Output Tray

The Face-up Output Tray
Then set the OUTPUT option in SelecType Level 1 for face-up
paper delivery. See Chapter 3 for instructions on using Selectype.
Removing the face-up output tray
When you need to remove the face-up tray from the printer for
transportation or other purposes, follow the steps below.
1. Remove the face-up tray from the drive unit.
2. Using a screwdriver, remove the four screws from the drive
unit and remove the drive unit.
3. Replace the rear cover with the four screws.
CAUTION: Never turn on the printer unless the rear
cover or the face-up tray drive unit is installed. You may
cause mechanical failure.
Appendix A A-19