Maintenance
Cleaning the Scanner
To keep your scanner operating at its best, clean it periodically using the following procedure.
c
Important:
❏ Do not press the glass surface of the scanner glass with any force.
❏ Be careful not to scratch or damage the glass surface of the scanner glass, and do not use a hard or abrasive
brush to clean it. A damaged glass surface can decrease the scan quality.
❏ Never use alcohol, thinner, or corrosive solvent to clean the scanner. ese chemicals can damage the product
components and the case.
❏ Be careful not to spill liquid into the scanner mechanism or electronic components.
is
could permanently
damage the mechanism and circuitry.
❏ Do not spray lubricants on the scanner.
❏ Never open the scanner case.
1. Turn o the scanner.
2. Unplug the power cord from the scanner.
3. Clean the outer case with a cloth dampened with mild detergent and water.
4. If the glass surface gets dirty, clean it with a so dry cloth. If the glass surface is stained with grease or some
other hard-to-remove material, use a small amount of glass cleaner and a so cloth to remove it. Wipe o all
remaining liquid.
Make sure that dust does not build up on the glass surface. Dust can cause spots and straight lines in your
scanned images.
c
Important:
Do not spray glass cleaner directly on the glass surface.
5.
Clean the document cover if it gets dirty.
Related Information
& “Part Names” on page 10
Energy Saving
You can save energy by using the sleep mode or auto power o mode when no operations are performed by the
scanner. You can set the time period before the scanner enters sleep mode and turns o automatically. Any
increase will aect the product’s energy eciency. Consider the environment before making any changes.
User's Guide
Maintenance
51
To Next Page
Loading...
