3. Select Fax on the printer's control panel.
To select an item, use the
u
d
l
r
buttons, and then press the OK button.
4. Pick up the handset.
If a message to start sending or receiving faxes is displayed as shown on the following screen, the connection
has been established.
Related Information
& “Making the Printer Ready to Send and Receive Faxes” on page 76
& “Making Settings to Use an Answering Machine” on page 79
& “Making Settings to Receive Faxes Operating Only a Connected Phone (Remote Receive)” on page 79
& “Receive Mode:” on page 219
Making the Printer Ready to Send and Receive Faxes
Fax Setting Wizard congures the basic fax features to make the printer ready to send and receive faxes.
e Wizard is displayed automatically when the printer is turned on for the rst time. You can also display the
wizard manually from the printer's control panel. You need to run the wizard again in case the wizard is skipped
when the printer is
rst
turned on or when the connection environment has changed.
❏ e items below are what you can set through the wizard.
❏ Header (Your Phone Number and Fax Header)
❏ Receive Mode (Auto or Manual)
❏ DRD Setting
❏ e items below are set automatically according to the connection environment.
❏ Dial Mode (such as Ton e or Pulse)
Fax Setting Wizard may not congure Dial Mode automatically when Line Type is set to PBX. Congure
Dial Mode manually.
❏ Other items in Basic Settings remain as they are.
Related Information
& “Basic Settings Menu” on page 217
Faxing
>
Before Using Fax Features
>
Making the Printer Ready to Send and Receive Faxes
76
To Next Page
Loading...
Need help?
General
