Epson L655 - Page 53

ConfidentialConfidential
Adjus
Adjusttmmeentnt DDeettaails ils oof Adf Adjustjustmmeentntss 6262
 Application procedure of Teflon tape.Application procedure of Teflon tape.
1. 1. Clean the surfaceClean the surfaces of the thickness s of the thickness gauge by using agauge by using alcohol, and make lcohol, and make sure no dirt or consure no dirt or contamination remains ontamination remains on
the surfaces.the surfaces.
2. 2. Apply Teflon Apply Teflon tape on tape on the thickness the thickness gauge agauge as shown s shown below.below.
FigurFigure 3-1.e 3-1. ModiModificatfication of Thiion of Thicknesckness Gauge (1s Gauge (1))
 Use commercially available Teflon tape of 0.08 Use commercially available Teflon tape of 0.08 mm in thickness.mm in thickness.
 When applying Teflon tape on the thickness gauges, make sure no When applying Teflon tape on the thickness gauges, make sure no bubbles or foreignbubbles or foreign
material remain under the tape.material remain under the tape.
[[BBuubbbblleess]] [[FFoorreeiiggn n mmaatteerriiaall]]
Teflon tapeTeflon tape
Thickness gaugeThickness gauge

E
E ppssoon n EE TT--44555500, , LL665555//665566 RReevviissiioon n BB
3. 3. Fold the excess Fold the excess portions of Teflon tape aportions of Teflon tape along the edges of long the edges of the thickness gauge, the thickness gauge, and trim the portions and trim the portions at aboutat about
the center in the thickness direction of the sides.the center in the thickness direction of the sides.
FigurFigure 3-2.e 3-2. ModiModificatfication of Thiion of Thicknesckness Gauge (2s Gauge (2))
When trimming the Teflon tape, the teflon tape can be easily cut out by guiding the halfWhen trimming the Teflon tape, the teflon tape can be easily cut out by guiding the half
thickness gauge.thickness gauge.
Before trimmingBefore trimming
After trimmingAfter trimming
TThhiicckknneesss s ggaauuggee TTeefflloon n ttaappee
Fold the tape at the edge and trim it at the center in the thickness direction.Fold the tape at the edge and trim it at the center in the thickness direction.