Confidentialî˜ Confidentialî˜
Adjus
Adjusttmmeentnt DDeettaails ils oof Adf Adjustjustmmeentntss 6464
FigurFigure 3-3.e 3-3. PositPosition of thion of the Thicke Thickness Gness Gaugeauge
3.3. Move the CMove the CR Unit to the rR Unit to the right and tight and to the left to mo the left to make sure thake sure that the CR Unat the CR Unit does not toit does not touch the gauch the gauges. If iuges. If itt
touches a gauge, the PG is narrower than the standard. In such a case, reassemble or replace the Printertouches a gauge, the PG is narrower than the standard. In such a case, reassemble or replace the Printer
Mechanism.Mechanism.
4.4. Move the CMove the CR Unit back iR Unit back in the middn the middle of the prle of the printer ainter and place thnd place the 1.76 mm the 1.76 mm thickneickness gaugess gauges protecs protected withted with
Teflon tape on the same points as in Step 2.Teflon tape on the same points as in Step 2.
5.5. Move thMove the CR Unit to e CR Unit to the righthe right and to the lt and to the left to maeft to make sure thke sure that the CR Unat the CR Unit touchit touches the gaues the gauges. If iges. If it does nott does not
touch any gauge, the PG is wider than the standard. In such a case, reassemble or replace the Printertouch any gauge, the PG is wider than the standard. In such a case, reassemble or replace the Printer
Mechanism.Mechanism.
To Next Page
Loading...
