2
Printing on Continuous Paper
2-15
R4C3730
Rev. C
A5 size Chap2.fm
8/23/99 Pass 0
R
Proof Sign-off:
<Crestec> _______
<Kimura> _______
<Crestec> _______
9. Slide the edge guides to the middle of the top paper guide.
Make sure that the printer cover and the paper guide cover
are closed.
Note:
Always close the printer cover before printing.
10. Make sure the printer is on. You may need to check and
change the printer driver settings as described in Chapter 4.
When the printer receives data, it automatically loads the
paper and starts printing. The printed pages are fed over the
paper guide toward the back of the printer.
11. After you finish printing, follow the steps in the next section
to tear off your printed document.
If the first printed line on your page appears too high or low,
you can fix this using the micro adjust feature. See “Adjusting
the Top-of-Form Position” on page 2-37.
2-17nn.eps
2-16b.eps
To Next Page
Loading...
