Epson LQ-570e - Removing the Push Tractor

2-12
Printing on Continuous Paper
To feed continuous paper to the standby position where you can
remove the paper, press the
Load/Eject
button. (See the Glossary
for an explanation of the standby position.) Then open the
sprocket covers of the tractor and remove the paper.
c
Caution:
Always tear off your printed document before you press the
Load/Eject
button. Reverse feeding several pages at a time may
cause a paper jam.
Removing the push tractor
To remove the tractor from the push position, follow these steps:
1. Remove any paper from the tractor as described in the
previous section.
2. Turn off the printer.
3. Remove the paper guide by holding both edges and lifting it
up.
4. Press the tractor’s lock tabs, tilt the tractor up, and lift it out
of the printer.