Low-noise mode
When this mode is set to On, the noise is reduced, but the printing speed is slower.
Disable IPsec/IP Filtering
You c an dis ab le IPsec/IP Filtering.
Link Speed & Duplex
You can select an appropriate Ethernet speed and duplex setting. If you select a setting other than
Auto, make sure the setting corresponds to the settings on the hub you are using.
Changing default settings
Follow these steps to enter the Default Setting mode and change the printer’s default settings:
Note:
❏ To print the Default Setting mode instructions, you need several sheets of A4 or Letter size
single-sheet paper, or several pages of continuous paper that is at least 279 mm (11 inches) long
and 210 mm (8.27 inches) wide.
❏ If you use single sheets, you need to feed a new sheet of paper each time the printer ejects a printed
sheet.
1. Make sure the printer is turned on and paper is loaded.
2. Press and hold the Menu (o and d) buttons until the Font lights start flashing.
The printer enters the Default Setting mode and prints a message prompting you to select the
language for the Default Setting menu. The language which is underlined indicates the current
setting.
3. If the language you want is not selected, press the Item d button until the printout indicates the
language you want.
Note:
You cannot change the language by the Item u button.
4. Press the Set (o ) button to select the desired language.
The printer prints a message asking if you wish to print all of the current settings.
LQ-690II/LQ-690IIN User’s Guide
Printer Basics 26
To Next Page
Loading...
