Note:
❏ If the paper feed roller rotates but the printer does not load the paper, completely remove the
paper and then insert it all the way into the printer again.
❏ If the paper feeds before you can adjust its position properly, increase the Manual feed wait
time in the Default Setting mode. See “Changing default settings” on page 26 for more
information.
After printing a sheet, the printer ejects it onto the sheet guide and the Paper Out and Pause
lights come on. If you are printing a multiple-page document, remove the printed sheet and insert
a new sheet into the sheet guide. The printer automatically advances the paper and resumes
printing.
Note:
If the printer does not eject the printed sheet, press the Load/Eject button.
Loading Special Paper
Multipart forms
Your printer can print on both single sheet and continuous multipart forms. It can use multipart
forms with up to seven parts including the original.
!
Caution:
Use only carbonless multipart forms.
When using multipart forms with a line of glue at the top of the form, load the forms with the
glued side first.
Before printing, set the paper-thickness lever to the appropriate position for your multipart
forms referring to the table in “Adjusting the Paper-thickness lever” on page 31.
You can load single sheet multipart forms from the sheet guide. For instructions, see “Loading
Single Sheets” on page 39. You can load continuous multipart forms in the same way as you load
ordinary continuous paper. For instructions, see “Loading Continuous Paper” on page 33.
LQ-690II/LQ-690IIN User’s Guide
Paper Handling 41
To Next Page
Loading...
