113
12. Attach the paper guide to the cut-sheet feeder as shown
below.
a. View from above
b. Release tab
13. Slide the left edge guide to the center until it stops at the guide
mark. Then slide the right edge guide to fit the size of paper
you will use.
Note:
❏ To remove the paper guide from the cut-sheet feeder, press both
release tabs and pull out the paper guide.
❏ Make sure the paper guide cover is open when you print.
You can easily switch between continuous paper and cut-sheet
feeder operation. See “Switching back to single sheets” for details.
a
b
To Next Page
Loading...
Need help?
General
