117
Roll paper holder
The optional roll paper holder (#8310) allows you to use your
printer with 216 mm (8.5 inch) roll paper like that used with telex
machines. This option is not available in all countries.
Follow these steps to install and use the roll paper holder:
1. Turn off the printer and remove the paper guide.
2. Position the roll paper holder beneath the printer as shown
below. Fit the two holes in the base onto the two positioning
pegs on the bottom of the printer.
c
Caution:
Be careful to avoid dropping the roll paper holder when lifting
the printer. Only the printer’s weight holds it in place.
3. Push the paper release lever to the single-sheet position.
To Next Page
Loading...
Need help?
General
