118
4. Cut the leading edge of the roll paper straight across. Slide
the roll paper holder shaft through the center of the paper roll.
5. Set the shaft and paper roll onto the roll paper holder. Orient
the roll so that paper feeds from the bottom of the roll. Then
turn on the printer.
6. Bring the leading edge of the paper up over the paper path
guide for single sheets and insert it into the printer path for
single sheets until you feel resistance.
7. Install the paper guide. Slide the left edge guide to the center
until it stops at the guide mark. Then slide the right edge guide
to the opposite guide mark.
To Next Page
Loading...
Need help?
General
