98
When you use side-crimped
multipart forms, the copies
may not align with the
original.
Raise the paper guide to keep the
printing position accurate.
The paper does not eject properly.
Cause What to do
The page may be too long. Tear off the fresh supply of paper and
eject the page from the printer. Use only
paper that is within the specified length
range described under “Printer
Specifications”.
When you switch between single sheets and continuous paper,
the beeper sounds three times and the Pause light comes on.
Cause What to do
You may have tried to change
the paper release lever
position while paper remained
in the printer.
Return the paper release lever to the
previous position and eject the paper.
Then change the paper release lever
position.
To Next Page
Loading...
Need help?
General
