Static electricity is causing sheets of paper to stick to each other.
Solutions
Fan the paper before loading. If the paper still does not feed, load one sheet of paper at a time.
Multiple sheets of paper feed at the same time during manual 2-sided printing.
Solutions
Remove any paper that is loaded in the paper source before you reload the paper.
Paper Out Error Occurs
Paper is not loaded in the center of the rear paper feeder.
Solutions
When a paper out error occurs although paper is loaded in the rear paper feeder, reload paper in the
center of the rear paper feeder.
Original Does Not Feed in the ADF
e following causes can be considered.
Originals that are not supported by the ADF are being used.
Solutions
Use originals supported by the ADF.
& “ADF Specications” on page 172
The originals are loaded incorrectly.
Solutions
Load originals in the correct direction, and slide the ADF edge guide against the edge of the originals.
Too many originals are loaded in the ADF.
Solutions
Do not load originals above the line indicated by the triangle symbol on the ADF.
Solving Problems
>
Cannot Print or Scan
>
Paper Does Not Feed Properly
115
To Next Page
Loading...
Need help?
General