Epson p10000 - Printing Trim Lines

27
Note: The built-in cutter may not be able to cut some types of media.
1. Before you print, select the Setup tab.
2. Press the Menu button.
3. Select Printer Setup and press the OK button.
4. Select Roll Paper Setup and press the OK button.
5. Select Auto Cut and press the OK button.
6. Select Off.
7. Press the OK button to save the setting.
8. Press the back button to exit the menu.
9. Run your print job.
10. Press the cut/feed media button.
11. Press and hold the down arrow button until your print is clear of the printer, then press the OK button
to cut the print.
Note: If you cannot cut the paper using the built-in cutter, press the down arrow button until your
print is clear of the printer and cut the print by hand.
Parent topic: Cutting Roll Paper
Printing Trim Lines
When you disable the Auto Cut setting, you can print a trim line (page line) between print jobs as a
guide for manual cutting.
1. Before you print, select the Setup tab.
2. Press the Menu button.
3. Select Printer Setup and press the OK button.
4. Select Roll Paper Setup and press the OK button.
5. Select Page Line and press the OK button.
6. Select On.
7. Press the OK button to save the setting.
8. Press the back button to exit the menu.