32
5. Align the right edge of the sheet with the vertical line on the roll paper cover.
6. Press the OK button.
The sheet feeds into printing position automatically.
7. Select one of these settings on the LCD screen:
• If the paper settings are correct, select Keep Settings Above.
• Select Change Settings and adjust the settings.
8. Press the OK button.
9. Run your print job.
After printing, the sheet stays in the printer.
10. To remove your print, hold the sheet and press the cut/feed media button.
Note: Store cut sheet media flat in its original packaging. Storing sheet media unprotected or on its
long or short edge can lead to excess paper curl, cause damage to the printer, and ruin your prints.
To Next Page
Loading...
