Paper Loading Direction
Load paper vertically along the left side of the rear paper
feed with the printable side facing up. If you load
horizontally, printing is not performed correctly.
Envelopes
Load the envelopes with the flap closed and facing to the
left.
Paper Handling
Precautions
❏ Read the instruction sheets supplied with the paper.
❏ Fan and align the edges of the paper before loading.
Do not fan or curl photo paper. Doing so may
damage the printable side.
❏ To print both sides of the paper, dry completely,
flatten one side, and then print the other side.
❏ If the paper is curled, flatten it or curl it slightly in
the opposite direction before loading. Printing on
curled paper may cause paper jams and smears on
the printout.
❏ Fan and align the edges of the envelopes before
loading. When the stacked envelopes are puffed up
with air, press them down to flatten them before
loading.
Unusable Paper
Do not use the following paper. Using paper in these
conditions may cause paper jams and smears on the
printout, or incorrect printing.
❏ Paper that is wavy, torn, cut, folded, damp, too
thick, too thin, paper that has stickers stuck to it or
that has partially printed characters.
❏ Envelopes that are curled or folded.
❏ Envelopes with adhesive surfaces on the flaps or
window envelopes.
❏ Envelopes that are too thin.
Selecting Paper Settings
When paper is loaded in the rear paper feed, the paper
size and paper type settings screen is displayed. Check
the current settings, and if they do not match the paper
you loaded, change the settings.
PM-520 Operation Guide
Preparing to Print
23
To Next Page
Loading...
Need help?
General
