Epson PowerLite 4300 User Manual

Registering and deleting projectors for monitoring
13
B After entering the details, click "Register" to start the
registration. When the message is displayed, click "OK".
To continue registering other projector(s), repeat Steps 1 and 2.
q
Projectors that have been registered using automatic search are searched
for again by projector name each time EasyMP Monitor is started.
C To end the registration operation, click in the top-right
corner of the window or click "Cancel".
The icon(s) of the projector(s) you registered will be displayed in
Grouping view or Detail list view.
Refer to s "Monitoring window layout" p.20 for details on using
the Grouping view and Detail list view.
Setting the range of addresses to do an automatic
search and registration
q
Projectors that are using a serial W TCP/IP conversion adapter cannot be
detected.
Procedures for automatic search
Procedure
A Right-click in Grouping view and select "New" - "Projector
(automatic search)".
The Create new projector (automatic registration) window will be
displayed.
If Detail list view is displayed, select New - Projector (automatic
search) from the Edit menu.
B Select the "Specify an address range and search." check box
and then enter "Start address" and "End address" in the
range.
Monitor Select this when you want monitoring to start.

Epson PowerLite 4300 Specifications

Display

native resolution	1024 x 768
aspect ratio	Supports 4:3, 16:9, 16:10
color light output	5200 lumens

Power

power supply voltage	100 – 240 V ±10%, 50/60 Hz AC
power consumption normal mode	464 W
power consumption ECO mode	383 W

Operating Environment

operating temperature	32 ˚ to 104 ˚F (0 ˚ to 40 ˚C)
fan noise normal mode	38 dB
fan noise ECO mode	32 dB

Weight and Dimensions

dimensions including feet	18.50" x 12.26" x 5.96"
dimensions excluding feet	18.5" x 12.26" x 5.31"
weight	15 lb