Maintaining the Projector 91
Resetting the Lamp Timer
After you replace the lamp, you need to reset the lamp timer using the
projector’s menu.
1. Plug the projector in and turn it on.
2. Press the
Menu button on the remote control, select Reset Lamp
Hours
from the Reset menu, then press Enter.
3. When you see the confirmation message, select
Yes, then press
Enter.
4. When you’re finished, press
Menu to exit the menu system.
Transporting the Projector
The projector contains many glass and precision parts. Follow these
guidelines to prevent injury or damage:
■ When hand-carrying the projector, you should use the handle to
lift it only a short distance (for example, to set it on a table).
■ When shipping the projector for repairs, use the original
packaging material if possible. If you do not have the original
packaging, use equivalent materials, placing plenty of cushioning
around the projector.
■ When transporting the projector a long distance, first place it in a
hard-shell shipping case, and then pack it in a firm box, placing
cushioning around the case.
note
The lamp usage timer shows
0H until you’ve used the
lamp for at least 10 hours.
note
Epson shall not be liable for
any damages incurred
during transportation.
To Next Page
Loading...
Need help?
General