Setting Up the Projector 27
Connecting an RGB Video Source
Follow these instructions to connect the projector to a video player or
satellite receiver that has an RGB video output port using the VGA
computer cable that came with the projector.
Before starting, make sure the projector and your DVD player or
other video source are turned off.
1. Connect one end of the VGA computer cable to the
Computer1(Component) or Computer2(Component) port on
the projector.
2. Connect the other end to the video port on your player.
3. To play sound through the projector, follow the instructions
beginning on page 29.
If you don’t need to make any other connections, you can plug in
your projector and turn it on. See page 32 for instructions.
If more than one device is connected to the projector, select
Computer 1 (RGB) or Computer 2 (RGB) as the source, depending
on which port you used, after projection starts by pressing the
Source
Search
button on the projector or the Comp1 or Comp2 button,
depending on which port you used, on the remote control. See
page 34.
To Next Page
Loading...
Need help?
General