Epson PowerLite Pro Z8150NL - Setting the Projector ID; Checking the Projector ID

Settings for Multiple Projectors
176
q
• Operation using the remote control is possible only for projectors that are
within the operating range of the remote control. s "Operating range of
remote control" p.23
• When Remote Control Type is set to Simple from Operation in the
configuration menu, you cannot set the remote control ID. s p.67
• IDs are ignored when the projector ID is set to Off or the remote control ID
is set to 0.
Setting the projector ID
Procedure
A During projection, press the [Menu] button and select
Extended - "Multi-Projection" from the configuration menu.
s "Using the Configuration Menu" p.55
B Select "Projector ID", and then press the [Enter] button.
C Select of one of the numbers from 1 to 9 to use as the ID and
then press the [Enter] button.
D Press the [Menu] button to close the configuration menu.
Checking the Projector ID
Use the following procedure to check the projector ID.
Remote Control