Network Menu
84
Mail Notification menu
When this is set, you receive an e-mail notification if a problem or warning occurs in the projector. s "Reading Problem Mail Notification Function"
p.133
Sub Menu Function
Mail Notification You can set whether or not (On/Off) to be notified by e-mail.
SMTP Server You can input the IP address
g for the SMTP server for the projector.
You can input a number from 0 to 255 in each field of the address. However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Port Number You can input the port number for the SMTP server. The default value is 25. You can input numbers between 1 to 65535.
Email Address 1/Email
Address 2/Email Address
3
You can input the e-mail address of the destination to send the notification e-mail to. You can register up to three destinations. You
can enter up to 64 single-byte alphanumeric characters for the e-mail addresses. You cannot enter more than 32 characters on the
configuration menu. When setting from Web Control, you can enter more than 32 characters. s p.129
Setting a Notification
Event
You can select the problems or warnings to be notified about by e-mail. When the selected problem or warning occurs in the
projector, an e-mail is sent to the specified Email Address notifying that a problem or warning has occurred. You can select
multiple items from the displayed items. Sender is Email Address 1.
To Next Page
Loading...
