Settings for Multiple Projectors
177
Procedure
A Set the remote control ID switch to On.
B During projection, while holding the [ID] button, press the
[Help] button.
When you press the buttons, the current Projector ID is displayed
on the projection screen. It disappears in about three seconds.
Setting the remote control ID
Procedure
A Set the remote control ID switch to On.
B While holding the [ID] button, press a number button to
select a number to match the ID of the projector you want to
operate. s "Checking the Projector ID" p.176
Once this setting has been made, the projector that can be operated by
the remote control is limited.
Remote Control
Remote Control
To Next Page
Loading...
