Epson PowerLite Pro Z8150NL - Attaching and Removing the Interface Cover; Removing

To Next Page

To Previous Page

Installing Optional and Supplied Accessories

193

: Flashing : Lit : Off

Attaching and Removing the Interface Cover

Removing

Procedure

A Loosen the screw. (Thumb screw available on the PowerLite

Pro Z8255NL/Z8455WUNL only.)

Status Indicator on

projector

Indicator on

Wireless LAN unit

The Wireless LAN unit not

connected or the Wireless

LAN Power setting on the

Wireless LAN menu is Off

The Wireless LAN unit

connected to the projector but

not connected to the network

The Wireless LAN unit

connected to the projector

and connected to the network

The Wireless LAN unit

connected to the projector,

connected to the network, and

communicating

Main Page

Default Chapter2
- Notations Used in this Guide2
- Table of Contents3
Introduction8
Projector Features9
- Ease of Use When Installed on a Ceiling Mount9
- Reliability You Can Depend on10
- Meets a Wide Range of Needs11
- Enhanced Security Functions12
- Easy to Handle12
- Monitoring and Control Functions12
- Taking Full Advantage of a Network Connection12
Part Names and Functions14
- Front/Top14
- Rear15
- Interface16
- Control Panel18
- Remote Control19
Useful Functions24
Changing the Projected Image25
- Automatically Detect Input Signal and Change the Projected Image25
- Search)25
- Switch to the Target Image Using the Remote Control26
Changing the Aspect Ratio of the Projected Image27
- Changing the Aspect Mode28
- (Powerlite Pro Z8450WUNL/Z8455WUNL)28
  - Input Port28
  - Projecting Images from a Computer29
- Changing the Aspect Mode30
- (Powerlite Pro Z8350WNL)30
  - Projecting Images from Video Equipment or from the HDMI1/2 Input Port30
  - Projecting Images from a Computer30
- Changing the Aspect Mode31
- (Powerlite Pro Z8150NL/Z8250NL/Z8255NL)31
Selecting the Projection Quality (Selecting Color Mode)34
Projecting Two Images Simultaneously (Split Screen)35
- Input Sources for Split Screen Projection35
- Operating Procedures36
- Restrictions During Split Screen Projection38
  - Operating Restrictions38
  - Restrictions Relating to Images38
Functions for Enhancing Projection39
- Hiding the Image Temporarily (Shutter)39
- Freezing the Image (Freeze)39
- Pointer Function (Pointer)40
- Enlarging Part of the Image (E-Zoom)41
Saving a User's Logo43
Security Functions45
- Managing Users (Password Protect)45
- Restricting Button Operation47
- Theft-Deterrent Lock50
  - Installing the Wire Lock50
Memory Function51
- Available Settings51
- Saving/Loading/Erasing the Memory51
Configuration Menu54
Using the Configuration Menu55
- Configuration Menu56
  - Network Menu58
Image Menu60
Signal Menu62
Settings Menu65
- Extended Menu67
- Network Menu70
- Info Menu (Display Only)89
- Reset Menu91
Troubleshooting92
- Using the Help93
- Problem Solving95
  - Reading the Indicators96
    - Indicator Is Lit or Flashing Red97
    - M O N Indicator Is Flashing or Lit99
  - When the Indicators Provide no Help101
Where to Get Help114
- Internet Support114
- Speak to a Support Representative114
- Purchase Supplies and Accessories114
Maintenance115
Cleaning116
- Cleaning the Projector's Surface116
- Cleaning the Lens116
- Cleaning the Air Filter116
Replacing Consumables119
- Replacing the Lamps119
- Replacing the Air Filter122
  - Air Filter Replacement Period122
  - How to Replace the Air Filter122
Notes on Transportation124
- Moving Nearby124
- When Transporting124
  - Preparing Packaging124
  - Notes When Packing and Transporting124
- Image Maintenance125
  - Panel Alignment125
Monitoring and Controls127
- Easymp Monitor128
- Changing Settings Using a Web Browser (Web Control)129
- Using the Mail Notification Function to Report Problems133
  - Reading Problem Mail Notification Function133
- Management Using SNMP134
- ESC/VP21 Commands135
- About Pjlink137
- About Crestron Roomview138
  - Operating a Projector from a Computer Window138
- About Message Broadcasting143
Network Functions144
Projecting with "Connect to a Network Projector145
Making a WPS (Wi-Fi Protected Setup) Connection with a Wireless146
LAN Access Point146
- Connection Setup Method146
  - Making a Connection Using the Push Button Method147
  - Making a Connection Using the PIN Code Method148
Installation and Connections151
Installation Methods152
Connecting to Equipment154
- Connecting to a Computer154
  - Changing the Video Output from a Laptop Computer155
- Connecting to Video Equipment156
Adjusting the Projected Image159
- Displaying a Test Pattern159
- Adjusting the Position of the Projected Image (Lens Shift)161
- Focusing the Image162
- Zooming the Image162
- Adjusting the Tilt of the Projected Image163
- Correcting Distortion in the Projected Image163
Adjusting the Image Quality171
- Hue, Saturation, and Brightness Adjustment171
- Gamma Adjustment171
- Frame Interpolation173
- (Powerlite Pro Z8450WUNL/Z8455WUNL Only)173
- Super-Resolution173
- Noise Reduction173
  - Mosquito NR174
Settings for Multiple Projectors175
- Preparation Flow175
- Requirements175
- Projector ID/Remote Control ID175
- Adjusting the Position of the Projected Image178
  - Point Correction178
- Checking the Color Mode180
- Using the Edge Blending Function180
- Adjusting to Match Colors on Multi-Projection182
- Displays the Image Partly Enlarged (Scale)183
Setting Schedule185
- Setting Methods185
- Clock186
  - Daylight Saving Time Screen186
- Schedule186
  - Clock / Schedule Setting Screen186
Connecting to External Equipment187
- Connecting a LAN Cable187
- Connecting to an External Monitor187
Installing Optional and Supplied Accessories188
- Removing and Attaching the Projector Lens Unit188
  - Removing188
  - Attaching189
- Installing the Wireless LAN Unit (V12H418P12)192
  - Attaching192
  - Reading the Wireless LAN Indicators192
- Attaching and Removing the Interface Cover193
  - Removing193
  - Attaching194
- Removing the Feet195
Appendix196
Optional Accessories and Consumables197
- Optional Accessories197
- Consumables197
Screen Size and Projection Distance198
Supported Monitor Displays200
- Computer Signals (Analog RGB)200
- Component Video200
- Composite Video/S-Video200
- Input Signals from HDMI1/2 Input Port201
- Input Signals from SDI Input Port (Powerlite Pro Z8450WUNL/Z8455WUNL Only)201
Supported Certificates202
- Client Certificate (PEAP-TLS/EAP-TLS)202
- Server Certificate (PEAP/PEAP-TLS/EAP-TLS/EAP-Fast)202
- Web Server Certificate (Secure HTTP)202
Specifications203
- Projector General Specifications203
Appearance207
Glossary208
General Notes211
- About Notations211
- Recycling211
- Important Safety Instructions211
  - Restriction of Use215
- FCC Compliance Statement215
  - For United States Users215
  - For Canadian Users216
- Wireless Telegraphy Act Regulations216
- Software Copyright216
- Trademarks255
- Copyright Notice255
  - A Note Concerning Responsible Use of Copyrighted Materials256
  - Copyright Attribution256

Epson PowerLite Pro Z8150NL - Attaching and Removing the Interface Cover; Removing

Table of Contents

Other manuals for Epson PowerLite Pro Z8150NL

Related product manuals