Saving a User's Logo
44
D Move the box to select the part of the image to use as the
User's Logo.
q
Your User’s Logo image can have a resolution up to 400 ^ 300.
E When "Select this image?" is displayed, select "Yes".
F Select the zoom factor from the zoom setting screen.
400% is displayed only when using PowerLite Pro
Z8450WUNL/Z8455WUNL.
G When the message "Save this image as the User's Logo?" is
displayed, select "Yes".
The image is saved. After the image has been saved, the message
"Completed." is displayed.
q
• To use the saved user's logo as the screen image, set it in the Display
settings under the Extended menu. s p.67
• Saving the user's logo may take approximately 15 seconds. Do not use the
projector or any connected equipment while it is saving, otherwise
malfunctions may occur.
Using the Remote Control Using the Control Panel
To Next Page
Loading...
