144
6
Click the [Print] button.
The disc on which there are five lines printed on the top, bottom, left and right respectively as well as one blue
upward-pointing arrow is output to Stacker 4 in Standard Mode and External Output Mode, and is output to
Stacker 3 in Batch Mode.
7
Click [Finish] if the lines on the top, bottom, left and right are evenly printed on the label
surface. If they are not printed evenly, adjust the alignment in one of the following ways.
• If the printing has shifted to the left: Select a positive correction value in [Horizontal].
• If the printing has shifted to the right: Select a negative correction value in [Horizontal].
• If the printing has shifted to the top: Select a positive correction value in [Vertical].
• If the printing has shifted to the bottom: Select a negative correction value in [Vertical].
To Next Page
Loading...
Need help?
General
