EPSON Stylus Photo R200/R210 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 41
o When reassembling "ASF Unit",
n Make sure that "Extension Spring, 0.45" is hooked on
"Frame, ASF" and "Roller, Retard Assy.".
n Make sure that "Torsion Spring, 6.45" is correctly installed
on "Paper Return Lever" and "Frame, ASF".
Figure 2-7. "Torsion Spring, 6.45" removal
n Make sure that "Paper Return Lever" and "Roller, Retard
Assy." move smoothly.
n Do not touch the cork of "Hopper".
o When reinstalling "ASF Unit",
n Install "Compression Spring, 2.51" on "Hopper", then
check if "Hopper" moves smoothly.
n Screw in the order as shown in the figure.
n Make sure that there is no gap between "ASF Unit" and
"Frame, Main".
Torsion Spring, 6.45
A D J U S T M E N T
R E Q U I R E D
o When having replaced "ASF Unit", apply G-46 grease to the
specified points in adequate dose. (Refer to Chapter 4
"MAINTENANCE")
o When having replaced or removed "ASF Unit", implement the
adjustment in the following order. (Refer to Chapter 3
"ADJUSTMENT")
1. First Dot Adjustment
To Next Page
Loading...
