EPSON Stylus Photo R200/R210 Revision A
TROUBLESHOOTING Troubleshooting with LED/LCD Indications and Status Monitor 3 Message 9
1.2 Troubleshooting with LED/LCD Indications and Status Monitor 3 Message
This section describes the LED/LCD indication, the STM3 message and the error condition when the printer detects an error in each operation such as the power on, the paper
loading/feeding and the ink absorption operation. (As for the screen shot in STM3 message, it’s used screen shot of Stylus Photo R300/310 as a substitute for that of Stylus Photo
R200/210.)
Table 1-3. LED Indication and STM3
Printer status
LED indication
STM3 message Condition for error detection
Power Paper Ink
Communication Error -- -- --
This error is detected when the printer cannot
communicate with the PC properly.
Error before Initial Ink
Charge
Blink -- On
This error is detected when a defective cartridge
is installed in the printer which the Initial Ink
Filling is not done yet.
To Next Page
Loading...
