Epson R200 - Stylus Photo Color Inkjet Printer - 2.3.9 APG Unit Removal

EPSON Stylus Photo R200/R210 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 49
2.3.9 APG Unit removal
o External View
Figure 2-18. "APG Unit" removal
o Parts/Units which should be removed before removing "APG Unit"
Paper Support Assy./Housing (left/right)/Housing (frame)/ASF Unit/Board, Main
o Disassembly Procedure
1. Disconnect the APG motor connector cable from the connector (CN13) of
"Main Board"."
2. Remove the screw (x1) for securing "APG Unit", and remove the "APG Unit"
carefully.
C.B.S 3x6 (6-8kgf/cm)
APG Unit
Shield Plate, M/B
Left backside
o When reassembling "APG Unit",
n Make sure that the hooks (x2) and the dowels (x2) of "APG
Unit" are securely attached to "Frame, Main".
n Check if the part indicated in the following figure is inserted
in the slits of "Frame, Main".
Figure 2-19. "APG Unit" installation
Hook
APG Unit
Dowel
It has to be inserted in the
slit of "Frame, Main"