Epson R200 - Stylus Photo Color Inkjet Printer - Page 48

EPSON Stylus Photo R200/R210 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 48
o When reinstalling "Clutch",
n Make sure that the dowel of "Shaft, LD Roller" is fitted in
the installing hole of "Clutch".
n Make sure that "Extension Spring, 0.143" is securely set on
the hooks of "Clutch" and "Shaft, LD Roller".
n Do not set "Extension Spring, 0.143" in twisted form.
n Make sure that "Clutch" rotates correctly.
o When reinstalling "Shaft, LD Roller",
n Do not touch "LD Roller".
n Check if the straight part of "Torsion Spring, 137.7" is set
between the 2 cams of "Shaft, LD Roller".
Figure 2-16. Position of "Torsion Spring, 137.7"
Torsion Spring, 137.7
Make sure that the straight part of "Torsion
Spring, 137.7" is set between the two cams.
LD Roller
o When reinstalling "Holder, Shaft Unit",
n Check if the hooks (x2), the dowel and the ribs (x5) of
"Holder, Shaft Assy." are correctly secured.
n Check if the connector cable of "PE Sensor" and "Cable,
Head" are installed at the correct position of "Holder, Shaft
Assy.".
n Do not touch "LD Roller".
n Do not damage the teeth of "Spur Gear, 36.8" and
"Combination Gear, 27.2, 19.2".
Figure 2-17. "Spur Gear, 36.8" and "Combination Gear, 27.2, 19.2"
A D J U S T M E N T
R E Q U I R E D
o When having replaced "Shaft, LD Roller", apply G-46 grease to
the specified points in adequate dose. (Refer to Chapter 4
"MAINTENANCE")
o When having replaced or removed "Holder, Shaft Unit",
implement the following adjustment. (Refer to Chapter 3
"ADJUSTMENT")
n First Dot Adjustment
Spur Gear, 36.8
Combination Gear, 27.2, 19.2