Epson R200 - Stylus Photo Color Inkjet Printer - 2.3.2 Housing (Frame);Panel Assy.;Panel Board Removal

EPSON Stylus Photo R200/R210 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 39
2.3.2 Housing (frame)/Panel Assy./Panel Board removal
o External View
Figure 2-4. Housing (frame) removal
o Parts/Units which should be removed before removing Housing (frame)/
Panel assy./Panel board
Paper Support Assy./Housing (left/right)/Stacker Assy.
o Disassembly Procedure
n Housing (frame) removal
1. Remove the screw ( , x1) for securing the housing (frame) to the printer
mechanism.
2. Remove the screw ( , x1) for securing the "Cover, Ink tube" to the housing
(frame), and release the hook ( , x1) of the cover.
3. Release the hooks ( , x3) for securing the backside of the housing (frame).
4. Release the hooks ( , x2) for securing the front side of the housing (frame).
5. Remove the housing (frame) upward.
n Panel assy. removal
1. Release two hooks for securing the panel assy. to the housing (frame).
n Panel board removal
1. Remove the panel board upward.
1
Backside
Cover, Ink Tube
Left front side Right front side
C.B.S3x8(5‑7kgf/cm)
2
4 4 4
5
5
CN4
Panel FFC
3
Panel assy.
Housing, Frame
C.B.P2.5x8(3‑5kgf/cm)
o When reinstalling the housing (frame),
n You have to reeve the panel FFC to the hole of the housing
(frame) is inserted to the panel board before installing the
housing (frame).
n Make sure to connect panel FFC to the main board (CN4)/
panel board before installing the housing (frame).
Figure 2-5. Panel board installation
n Make sure that there is no clearance beteen the housing
(frame) and the housing (lower).
1
2
3
4
5
Panel board
Hole for reeving the panel FFC