Epson R200 - Stylus Photo Color Inkjet Printer - 2.3.12 Printer Mechanism;Housing (Lower) Removal

EPSON Stylus Photo R200/R210 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 57
2.3.12 Printer Mechanism/Housing (lower)
removal
o External View
Figure 2-29. "Printer Mechanism"/"Housing, Lower" removal (1)
Figure 2-30. "Printer Mechanism"/"Housing, Lower" removal (2)
o Parts/Units which should be removed before removing "Printer
Mechanism"/Housing (lower)
Paper Support Assy./Housing (left/right)/Housing (frame)/ASF Unit/Main Board/
Holder, Shaft Unit
o Disassembly Procedure
1. Move "Carriage Unit" to the centre of the printer.
2. Remove the screws (x3) for securing "Paper Guide, CDR".
3. Remove the screws (x5) for securing "Printer Mechanism".
4. Take off the acetate tape and release the connector of "Star Wheel/CDR
Sensor".
5. Cut off the wire band and release the connector cable.
6. Release the hooks (x4) for securing "Printer Mechanism". Then, hold the both
right and left upper edges of "Frame, Main" and remove "Printer Mechanism"
to upward.
C.B.P 3x8 (5-7kgf•cm)
C.B.S 3x6 (5-7kgf•cm)
Paper Guide, CDR
1 2
3
C.B.P 3x10 (6-8kgfcm)
C.B.S 3x6 (6-8kgf•cm)
1
2
Screw, Frame, Main (6-8kgf•cm)
4
C.B.P 3x10 (6-8kgf•cm)
Hook
(Under the tube)
3
5
Wire Band
Lever, ChangeCombination
Gear, 27.2, 19.2
Hooks
Hook
Acetate Tape
2 ± 1mm
Handling Position