Epson R200 - Stylus Photo Color Inkjet Printer - Page 63

EPSON Stylus Photo R200/R210 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 63
o External View (Cont.)
Figure 2-40. "CDR Guide Assy."removal (3)
8. Remove "Compression Spring, 5.1" and "Lock, Stacker" from "CDR Guide,
Upper".
9. Release the connector cable of "Star Wheel/CDR Sensor" from the groove of
"CDR Guide, Upper".
Compression Spring, 5.1
Lock, Stacker
Star Wheel/CDR Sensor
Groove
Hooks
Shaft and Positioning Hole
o When reinstalling "Star Wheel/CDR Sensor",
n Match the Shaft (x2) of "CDR Guide, Upper" and the
positioning hole of "Star Wheel/CDR Sensor".
n Mount correctly the connector cable of "Star Wheel/CDR
Sensor" referring to the figure.
o When reinstalling "CDR Guide, Upper"
n Make sure that the hooks (x2) of "Lock Stacker" are
properly secured by the tension of "Compression Spring,
5.1".
n Make sure that "CDR Guide, Upper" is securely secured
with the hooks (x7) of "CDR Guide, Lower" and there is no
gap between "CDR Guide, Upper" and "CDR Guide,
Lower".
o When reinstalling "CDR Guide Assy.",
n Place the the connector cable of "Star Wheel/CDR Sensor"
on the red circle position of acetate tape.
n Place the the connector cable of "Star Wheel/CDR Sensor"
along with "Link, CDR Right" with standing "CDR Tray
Assy." vertically.
n Install "CDR Guide Assy." in the order of left edge, right
edge and middle.
n Match the slot (x6) of "CDR Guide Assy." and the ribs (x6)
of "Frame, Main".
n Check if "Link, CDR Left (Right)" is correctly installed.
n Check if the connector cable of "Star Wheel/CDR Sensor" is
not interrupting "Link, CDR Right".
n Check if "Frame, EJ Assy." works with "CDR Guide Assy."
and moves smoothly.