EPSON Stylus Photo R200/R210 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 66
n Set all of the gears on the shaft of "Pump Frame" correctly,
and then check if they move smoothly.
n Make sure that the ink tube is not squashed or pressed.
n Install the ink tube to the grooves (x2) at the bottom surface
of "Cap Frame".
Figure 2-44. Installation point for the ink tube
o When reinstalling "Ink System"
n Check if "Pump Assy." is correctly secured.
n Do not let "Lever, Change", "Combination Gear, 27.2,
19.2", "Spur Gear, 27.2" and "Combination Gear, 20.82,
24" drop and break them.
To Next Page
Loading...
