Epson RX-8025SA - 9 External Dimensions; Marking Layout; External Dimensions; Marking Layout

RX - 8025 SA / NB
Page - 28 ETM10E-04
9. External Dimensions / Marking Layout
9.1. External Dimensions
RX-8025 SA (SOP-14pin)
• External dimensions • Recommended soldering
0.6
0.15
0° - 10°
1.4
1.4
5.4
1.27
1.27 × 6 = 7.62
0.7
Unit : mm
10.1
±
0.2
5.0 7.4
±
0.2
#14 #8
#7 #1
1.27 1.2
0.05
Min.
3.2
±
0.1
0.35
∗ The cylinder of the crystal oscillator can be seen in this area ( back and front ),
but it has no affect on the performance of the device.
RX-8025 NB (SON-22pin)
•
External dimensions
•
Soldering pattern
1.3
±
0.1
0.125
0.1
Unit : mm
6.3 Max.
5.0
±
0.2
4.8
0.5 0.2
#1
#22
#14
#11
#14
(0.3)
#11
#1
#22
0.8
P 0.5
×
10 = 5.0
1.4
0.5
5.25
0.25
0.7
0.75
0.25
0.8
0.7
4.0 0.7
0.7
#1
#11
#22
#14
∗1)
The cylinder of the crystal oscillator can be seen in this area ( back and front ),
but it has no affect on the performance of the device.
∗2)
In this area, At a parts side of electronic base, you must not do layout any signal line.
9.2. Marking Layout
RX - 8025 SA (SOP-14pin)
Logo
Type
Production lot
R 8025
E A123B
RX - 8025 NB (SON-22pin)
Logo
Type
Production lot
E
A
123
B
R
8025
∗ The layout shown above is a simplified drawing of the seal and label. Details such as the fonts, sizes, and positioning of
label contents are not necessarily as shown.