Settings item Settings value Explanation
Custom Paper Setting
(Touching any of the registry numbers from 01 to 10 will display settings items.)
Change Name Register and change the name of the custom paper settings. The
name registered here is displayed in the Paper Type list.
Touch this to display the keypad screen. Up to 20 characters may be
input for the name. The keypad screen can be switched as shown
below with the button marked.
Touch the icons at bottom left to switch between input methods.
ABC: Enters alphabet letters.
123#: Enters numbers and symbols.
To change the key layout of the full keyboard, use Keyboard in the
Basic Settings menu.
U “General Settings - Basic Settings” on page 91
Change Reference
Paper
Sublimation Transfer
Paper
You can select the media type that is the closest to the paper you are
using.
Advanced Media Setting
Platen Gap 1.6 This is the Platen Gap (distance between print head and paper) for the
paper selected in Change Reference Paper, so it does not normally
need to be changed. Change this to a setting that will widen the gap
(a higher value) if print results are smeared.
2.1
2.6
Top/Bottom Mar-
gins
Standard
*
Setting this to Standard will set the top/bottom margins as follows
depending on the printer driver print targets.
❏ CAD Line Drawing: 3 mm/3 mm
❏ Others: 30 mm/30 mm
Left and right margins will remain at 3 mm regardless of settings. If
there is any soiling on the top section of the print results, increase the
top margin.
U “Printable area” on page 132
Top 3 mm/Bottom 3 mm
Top 15 mm/Bottom 15 mm
Top 45 mm/Bottom 15 mm
Back Tension
Auto
*
If there is any wrinkling on the paper during printing, select High or
Extra High.
Standard
High
Extra High
SC-F500 Series User's Guide
Using the Menu
94
To Next Page
Loading...
Need help?
General
