Epson SC-F9200 series User Manual

K
At the rear of the printer, remove the
counterweight attached to film a.
L
Pull out film a from the printer.
M
Bring film a to the left side of film b.
Pass the lead edge of film a by the front of the
media guide bar and then insert it into the
printer.
N
At the front and rear of the printer, raise film a
and move it so that it aligns with film b tightly.
At the rear of the printer, attach a counterweight
to film a.
O
After film a stops swinging, make a note of the
value of the scale on film a where the edge of the
platen overlaps.
SC-F9200 Series User's Guide
Appendix
126

Epson SC-F9200 series Specifications

General

Brand	Epson
Model	SC-F9200 series
Category	Printer
Language	English