Epson SC-F9200 series User Manual

Move the media holding plates to the right and
left sides of the platen. Hold both tabs on the
media holding plates to move them.
C
Close the front cover.
D
Loosen the roll holder fixing screws sufficiently
and adjust the roll holders so that the distance
between the two is wider than the media.
Center the roll supports between the roll holders.
c
Important:
If the right holder handle shaft is not visible,
rotate the handle forward until it stops. The
media cannot be properly loaded if the handle
shaft is not visible.
E
Temporarily place media on the roll supports.
Note:
The method of placing the roll media varies as
follows depending on how the media is rolled.
Printable Side Out
Printable Side In
F
Align the left edge of the media with the position
on the label.
SC-F9200 Series User's Guide
Basic Operations
27

Epson SC-F9200 series Specifications

General

Brand	Epson
Model	SC-F9200 series
Category	Printer
Language	English