To Next Page

To Previous Page

1 to 30 (media setting bank number)

Item Parameter Explanation

Setting Name - Assign the media setting bank a name up to 22 half-size characters long.

Using distinctive names makes it easier to select banks for use.

Feed Adjustment Manual Use this option if banding (horizontal banding, tint unevenness, or stripes)

persists after head cleaning and head alignment have been performed.

The user visually inspects print results and enters the adjustment value by

hand. U “Feed Adjustment” on page 49

Adjustment varies with the media being used. Load the media for which

feed adjustment is required under the same conditions as the actual print

job.

Platen Gap 1.5 Choose the platen gap (the distance between the print head and the

media).

The default setting is recommended in most circumstances. Raise the

setting by one level if printout is scratched or smudged. Select 2.5 only if

print results are still smudged when 2.0 is selected. Choosing a larger gap

than required may result in ink stains inside the printer, reduced print

quality, or shorter product life.

2.0

2.5

Head Alignment

Manual(Uni-D) Print Select Head Alignment to realign the print head when print results seem

grainy or out of focus. When printing in both directions, select

Manual(Bi-D). If the graininess or misalignment is not improved after

performing Manual(Bi-D), try Manual(Dual Head). If there is still no

improvement, perform Manual(Uni-D). When printing in one direction,

select Manual(Dual Head). If the graininess or misalignment is not

improved after performing Manual(Dual Head), perform

Manual(Uni-D).

U “Correcting Print Misalignment (Head Alignment)” on page 48

Manual(Bi-D)

Manual(Dual

Head)

Heating & Drying

SC-F9200 Series User's Guide

Using the Control Panel Menu

Epson SC-F9200 series User Manual

Other manuals for Epson SC-F9200 series