Epson SC-F9200 series User Manual

Item Parameter Explanation
Heater
Temperature
Off Set the after heater temperature.
The default Heater Temperature is 50 ˚C.
30 to 55˚
Drying Time Per
Pass
0 to 10 sec Select the time the print head pauses to allow drying after each pass.
Choose from values between 0.0 and 10.0 seconds. When you want to
maintain a constant drying time even when the print width changes, set
the drying time according to the media width. See the following for more
information.
U “Heating & Drying” on page 45
The time needed for the ink to dry varies with ink density and the media
used. If the ink blurs on the media, set a longer time than the
recommended value for drying the ink.
Increasing the drying time increases the time needed to print.
After Heater Feed On
Select whether to feed media to the after heater after printing (On/Off).
Select On if the media will be cut before the next job starts. Note, however,
that the margin will increase.
Off
Blank Area Feed Mode 0 If there is a section without print data (a blank area) during a job, the media
is fed quickly. If the value for the selected mode is small, the media is fed at
a quicker speed. If this mode does not allow the ink to dry sufficiently, see
the following section and change the mode.
U “Heating & Drying” on page 45
Mode 1
Mode 2
Mode 3
Media Suction 0 to 10 Suction is required to maintain the correct distance between the media
and the print head; the amount needed varies with the type of media.
Excessive Media Suction can increase the gap between the print head
and thin or flexible media, potentially reducing print quality or preventing
the media feeding normally. In such cases, you will need to lower the
Media Suction. The Media Suction power is weakened when the
parameter is lowered.
Head Movement
Data Width Choose the range in which the print head moves during printing.
Data Width restricts print head movement to the printed area. Restricting
the extent of print head movement increases print speed.
If Printer Full Width is selected, the print head will move the full width of
the largest media supported by the printer. Select this option for more
even print results with less variation.
Printer Full Width
Multi-Strike Printing
Off Choose the number of times each line is printed.
2 to 8
Roll Type
Printable Side Out
Choose Printable Side Out or Printable Side In according to how the
media is rolled.
Printable Side In
Tension Measurement
Periodically The tension is measured and adjusted automatically to maintain the
correct tension for the media being printed.
Periodically is recommended in most circumstances.
Select Every Page for more precise tensioning, but note that print times
will increase.
Every Page
Feeding Tension
SC-F9200 Series User's Guide
Using the Control Panel Menu
94

Epson SC-F9200 series Specifications

General

Brand	Epson
Model	SC-F9200 series
Category	Printer
Language	English