Epson SC-S60600 Series Operator's Guide

2. Select the roll winding specifications
Select the roll type for the loaded media roll.
3. Set the media length
Set the length of the loaded media.
Buttons that are used in the following settings
A
Use the d/u buttons to select the media setting
number to which the print settings have been
registered, and then press the Z button.
OK Done
1
2
3
4
5
Select Media
If media settings have not yet been made for new
media, select an unassigned number, finish
loading the media, and then perform Easy Media
Setup.
Making Media Settings U User's Guide (Online
Manual)
B
Use the d/u buttons to select the roll type that
matches the loaded roll, and then press the Z
button.
OK Done
Printable Side Out
Printable Side In
Roll Type
Back
C
The screen where you can enter the length of the
loaded media is displayed.
Use the d/u buttons to choose a length between
1.0 and 100.0 m and press the Z button.
OK Done
Range: O,1.0 - 100.0 m
Current: 30.0 m
Length
O
30.0 m
Set the value when remaining amount of media is
printed on the roll.
Press the r button if you want to select OFF. If
you select OFF, the remaining amount is not
calculated.
Note:
Two functions are enabled in Remaining
Setup - ON
The following two functions give you a rough idea
of the amount of media available before printing,
making it easier to know when media requires
replacement.
❏ Showing Amount of Media Remaining
The control panel display shows the
approximate amount of media remaining
based on the length set for the media and the
amount used during printing.
❏ Remaining Alert
A warning is displayed when the amount of
media remaining reaches a specified level.
SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series Operator's Guide
Basic Operations
19

Epson SC-S60600 Series Specifications

General

Brand	Epson
Model	SC-S60600 Series
Category	Printer
Language	English