29
Chapter 2
Using the Chronograph Function
· It usually takes within two minutes to complete a GPS search. If the GPS search does not
nish after three minutes or more, you may be in an environment where GPS signals
cannot be received. Select [Cancel] to stop the search, and then try again in another
location.
· If the GPS search does not nish after 10 minutes, the search is stopped and the [Menu]
screen is displayed.
· If you select [GPS o] on the [Searching] screen, the GPS sensor turns o which allows you
to use the chronograph function. However, measurement items are limited at this time
(
P. 21).
· See "Setting GPS (GPS search)" (
P. 24) for more details on making a GPS search.
· If 60 minutes pass without any measurements being made (if the device is stopped or
before measuring), the [Menu] screen is displayed.
To Next Page
