Epson SS-300 - 8-2 Screen Settings

75
Chapter 8
About Settings
8-2 Screen settings
You can change the measurement items displayed on each level of the chronograph screen.
Display items
Display item Display name Display example* More information
Distance Dist.
Total distance from start of
measurements
Pace Pace
Current pace
Lap pace PaceLa
Average pace for each section
Average pace PaceAv
Average pace from start of
measurements
Speed Speed
Current speed
Split time Spl
Total time from start of measurements
Lap time Lap
Time for each section
Pitch*² Pitch
Current pitch
Stride*² Stride
Current stride
Time Time
Current time
Calories burnt Cal.
Current calories burnt through
exercise
Altitude*³ Alti.
Current altitude
HR *² HR
Current heart rate
HR lap*² HR Lap
Average heart rate for current lap
Average HR*² HR Avg.
Average heart rate from start of
measurements
Guide time*⁴ Guide
Progress time towards target pace
(reaching target or falling behind)
Guide distance*⁴ Guide
Progress distance towards target pace
(reaching target or falling behind)
*1: Display example when [Settings] - [Sys.Settings] - [Distance Units] is set to "km".
*2: Only displayed for the SS-700/SS-500.
*3: Altitude measurements are taken using the GPS signal. There may be a large error in altitude measurements depending on
the GPS reception environment and so on.
*4: Although the display name is always the same, "Guide", the guide time and distance are dierentiated by numbers or units.