Epson SS-300 - 7-2 Wearing the HR Sensor Set

64
Chapter 7
Measuring Heart Rate (SS-700/SS-500 Only)
7-2 Wearing the HR sensor set
Wear the HR belt so that the electrode section of the HR belt is
pressed against your chest.
Adjust the HR belt so that it is not too tight.
· You can perform stable measurements when the electrode section of the HR belt is a little
wet.
HR sensor set - rear
HR sensor HR belt
Electrode
· You need to perform pairing in advance when using the HR sensor set for the rst time ( P. 65).
· When you are wearing the HR sensor set, turn on the [HR Sensor] ( P. 67).