1-16
16 | Setting Up the Printer On a Network
Configuring the Network Interface
1. Make sure that the printer is turned on and the LCD displays READY.
2. Press the
Menu r button on the printer’s control panel to enter the
printer’s menu system.
3. Press d to highlight
NETWORK SETUP, then press r.
4. Press r then d to highlight
ENABLE.
5. Press Enter. An asterisk appears next to ENABLE to show that it’s
selected.
6. Press l then d to highlight
IP ADDRESS SETTING.
7. Press r and then u or d to choose one of the following IP configuration
settings:
•AUTO: Select this setting if your network uses a DHCP server to
configure your network devices’ IP settings automatically.
•PANEL: Select this setting if you would like to configure the
printer’s IP settings manually.
8. Press Enter. An asterisk appears next to the setting you selected.
9. Press l to go back. Then do one of the following:
• If you selected AUTO as the IP ADDRESS SETTING, press the
+ Cancel button to exit the printer menu. Then continue with
step 14.
• If you selected PANEL as the IP ADDRESS SETTING, continue
with step 10.
10. Press d to highlight
IP, SM, DG SETTING, then press r. The LCD
displays the
IP ADDRESS.
11. Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press
r. The
LCD displays the
SUBNET MASK.
Note: If you don’t know
which setting to use, see
your network administrator
for help configuring the
printer’s IP settings.
sp3800Guide.book Page 16 Monday, January 29, 2007 11:08 AM
To Next Page
Loading...
