1-17
Setting Up the Printer On a Network | 17
12. Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press
r. The
LCD displays the
DEFAULT GATEWAY.
13. Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press Enter,
then press the
+ Cancel button to exit the printer menu.
14. Turn the printer off then back on again.
15. Make sure that the printer displays
READY and that you have at least
three sheets of plain, letter-size paper loaded in the printer’s auto sheet
feeder. Then press the
Menu r button to enter the printer menu.
16. Press d to highlight
TEST PRINT, then press r.
17. Press d to highlight
NETWORK STATUS SHEET, then press r.
18. Press Enter to print the network status sheet and verify that the IP
address settings are correct. Then see “Installing the Software for
Macintosh” below, or “Installing the Software for Windows” on
page 22.
Installing the Software for Macintosh
1. Turn on your Macintosh and your printer.
2. Insert the printer software CD-ROM. If necessary, double-click the
Epson CD-ROM icon to open its window.
3. Double-click the
Epson installer icon.
Note: You can check for a
newer version of your
printer driver on the
Epson support site at
epson.com/support.
sp3800Guide.book Page 17 Monday, January 29, 2007 11:08 AM
To Next Page
Loading...
