5-88
88 | Maintaining and Transporting the Printer
5. Press d or u to select the type of paper you loaded: PREM.
GLOSSY/LUSTER
, P Q INK JET PAPER (Epson Presentation Paper
Matte), or
ENHANCED MATTE PAPER (Ultra Premium Presentation
Paper Matte). Then press r.
6. Press
Enter to start printing. After printing is complete, the printer
starts aligning the print head.
It takes several minutes to run the head alignment. The printer’s white
beam sensor reads the alignment pattern and adjusts the printer
automatically. Make sure you don’t open the top cover or turn off the
printer during this process.
If you want to verify or fine-tune the alignment process, you can perform a
manual head alignment. See your on-screen User’s Guide for instructions.
Replacing Ink Cartridges
Before you begin a large print job, you should check your ink levels. If one of
your cartridges is low, you can replace it before you start. Or you can wait
until the ink cartridge needs to be replaced, and then continue the job
without any loss of print quality. However, it is best to replace a low ink
cartridge before starting a large print job.
The easiest way to check ink levels is from the control panel:
1 Matte Black
3 Light Black
2 Photo Black
4 Light Light Black
7 Light Cyan
9 Yellow
5 Cyan
8 Light Magenta
6 Magenta
sp3800Guide.book Page 88 Monday, January 29, 2007 11:08 AM
To Next Page
Loading...
