5-96
96 | Maintaining and Transporting the Printer
Using Maintenance Mode
Maintenance mode allows you to change the language or units of
measurements used in the printer’s menus and return all the menu settings
to their default values.
Follow these steps to use maintenance mode:
1. Make sure the printer is turned off.
2. Press and hold the + Cancel button, then press the P Power button
until the printer turns on.
MAINTENANCE MODE appears on the
LCD panel.
3. Press u or d to select the settings described below. If you need to back
up to the previous menu level, press the l button.
• To change the language displayed on the LCD panel, select
LANGUAGE and press r. Press d until you see the language you
want, then press
Enter to select it. Press l to return to the menu
or + Cancel to exit.
• To change the units of measurement, select UNIT and press r.
Select
METRIC or FEET/INCH and then press Enter to select it.
Press l to return to the menu or + Cancel to exit.
• To return all control panel settings to their default values, select
DEFAULT PANEL and press r. Press Enter to restore the
printer’s defaults. Then press l to return to the menu or + Cancel
to exit.
4. To exit maintenance mode, turn off the printer by pressing the P Power
button. Press the P Power button again to turn on the printer in the
normal operating mode.
sp3800Guide.book Page 96 Monday, January 29, 2007 11:08 AM
To Next Page
Loading...
